Baby Incubation Open Care System with Inbuilt Printer
Our open care system that comes in fiber and powder coated MS, allow you
to efficiently care and provide advance-warming capabilities while
using one-touch operations to simplify procedures. Advance
microprocessor controlled system with self-check on the electronic
circuitry skin/air/manual control. Latest technology packed with higher
accuracy & enhance visibility has been integrated in the system.
Control Panel
This open care system comes with automatic manual and baby (Servo) modes.
Big separate display for both skin and air temperature. Display can be converted from ˚C to ˚F by the push of a button. A big LCD is provided for more information and visualizations of the heater power in manual and servo modes. A full panel of alarms provides safety and convenience, with both audible and visual indicators in the event of:
- High Temp/Low Temp
- Power Failure
- System Fail
- Timer –on
- Probe Failure
- Heater fail/ON (optional) only visual alarm provided
The heater assembly located above the centre of the support structure consists of an integral examination light and a 650 watts heating system (Silica/Quartz/Ceramic Heater) for quick warming and even distribution of the heat of the baby bed. The heater can be swivelled in either direction for taking X-ray and doing procedures. The heater is also equipped with LED Phototherapy on both side to provide light intensity effective on the baby bed.
Air Mode
The system comes with air sensor. This is added security cover with exclusive feature of switching OFF the heater in case the air temperature goes above 39˚C irrespective of what the skin temperature is at the time of event.
Technical Specification
- Height- 1850mm
- Length-1050mm
- Width-650mm
- Power Supply-200V/50Htz
- Heater Power-650 Watts
- Fuse-5 Amp
This system automatically starts heating from 40% in manual mode and same can be changed through settings up to 100%. The system automatically converts from servo mode to manual mode in case of probe failure thus providing nonstop working of the unit.
Led Phototherapy
It comes with choice of highly efficient and bright 12/15choice of LEDs on each side of heater. The strong lux of 24/30 LEDs cure jaundice in baby rapidly.
Technical specification
Light Source:- High Bright Blue/White LEDs
Additional Features
If needed the unit can be programmed by the user itself for any of the following features:
a) Count Up/ Down Timer.
b) Check Baby alarm (Optional).
c) Pre warming mode.
Baby Bed
The spacious baby bed incorporates easy drop down/fold down glasses for maximum access to the patient. Optional: X-ray facility is provided below the baby bed for taking X-ray of the baby without disturbing.
Infant Resuscitator
- The range of flow adjustment is 5LPM ̃ 15LPM.
- The MAX-P and PIP are safe, controlled and accurate.
- The PEER is constant and accurate.
- Simple operation and flexible application.
Manual Printer fitted in the unit gives you real time print out of the event when required by pressing the switch on the control unit.
Optional
- Resuscitator
- Suction
- Oxygen
